Full Kit
+ Battery and antenna pads
+ 15mm hardware and carbon spacers
+ TPU camera dome
*10mm hardware still included.
This Hyperlow mid-mount racing frame features a new approach to arm design developed by Bob Roogi (Hyperlite/Floss); a double stack assembly with all the benefits of a vertical arm, and none of the drawbacks.
At 10mm tall and 4.5mm wide, the arms allow for the motor mount to be cut from the layer, with the bottom layer adding extremely rigid support and the benefit of aerodynamic positioning. The arms then double as standoffs, with the kit only needing a total of two for camera mounting.
Mid-mount battery positioning helps gives the frame fluid maneuverability, while a double strap plate and adequate prop berth can house up to a 1600 (Who Cares:) lipo safely.
A 15mm double stack can be built using THESE 3D PRINTED SPACERS above and below each arm.
For additional support, and to provide feedback, please refer to the HYPERLOW PILOT PAGE on Facebook.
This product was added to our catalog on Saturday 27 January, 2018.
