The Happymodel X12 is a 5-in-1 AIO board featuring an F4 Flight Controller, onbard 12A 4-in-1 ESC, 5.8GHz OpenVTX, and three different receiver options: PNP, FrSky, or ELRS. This AIO is great for brushless whoops with its great RX an VTX range!
Features
- PNP, FrSky, or ELRS Receiver Options
- Great for 1-2S Brushless Whoops
- Onbard 12A 4-in-1 ESC
- F4 Flight Controller
- 5.8GHz OpenVTX
- 5-in1 AIO Board
Specifications
- Item Name: X12 AIO 5-IN-1 Flight controller built-in 12A ESC and OPENVTX
- ELRS Version: CRAZYBEEF4SX1280
- LITE Version:CRAZYBEEF4SX1280
- FRSKY Version:CRAZYBEEF4FR
- PNP Version:CRAZYBEEF4DX
- Support 1-2S Lipo/LIHV battery
- Brand Name: Happymodel
- Betaflight firmware target:
- Size: 30x30x8mm
- VTX antenna: U.FL
- Weight: 5.1g
FLIGHT CONTROLLER
- Built-in voltage meter sensor , voltage meter scale 110Built-in current meter sensor , current meter scale 470
- Reciever Target:
- X12 ELRS V2.0 flight controller built-in ELRS 2.4G receiver Target: CRAZYBEEF4SX1280
- X12 Frsky V1.0 flight controller built-in FRSKY 2.4G receiver Target: CRAZYBEEF4FR
- X12 PNP V1.0 flight controller without onboard receiver Target CRAZYBEEF4DX
- X12 LITE V1.0 flight controller built-in ELRS 2.4G receiver Target:CRAZYBEEF4SX1280
- Sensor: MPU6000 or ICM20689 or BMI270(SPI connection)
- MCU:STM32F411CEU6 (100MHZ, 512K FLASH)
- Power supply: 1-2S battery input (DC 2.9V-8.7V)
- Built-in ExpressLRS 2.4G,Frsky D8/D16
- Built-in 5.8G OpenVTX 0mw~400mw
- Built-in 12A(each) Blheli_S 4in1 ESC
- Built-in Betaflight OSD(SPI Control)
- Mount hole size: 25.5mm*25.5mm
ONBOARD 4-IN-1 ESC
- When use Blujay firmware with 48khz, should set startup power to 1100/1200
- Current: 12A continuous peak 15A (3 seconds)
- Factory firmware: Z_H_30_REV16_7.HEX
- Support BLHeliSuite programmable
- Power supply: 1-2S LiPo/LiPo HV
- Default protocol: DSHOT300
- Support Bluejay firmware
ONBOARD 5.8GHZ VTX
- Transmitting Power: 0/RCE/25mw/100mw/400mw
- Current (5v): <650ma (400mw)
- Firmware version: OPENVTX
- Antenna connector: U.FL
- Power supply: DC 5V
- RCE Mode support
- PIT Mode support
- SmartAudio v2.1
- Channels:48ch
RECEIVER OPTIONS - PNP, ELRS, FRSKY
ONBOARD SPI ELRS 2.4GHz
- Packet Rate option: 50Hz/150Hz/250Hz/500Hz
- ExpressLRS Firmware version: V2.0
- RF Frequency: 2.4GHz
- Antenna : SMD antenna
- Telemetry output Power: <12dBm
- Receiver protocol: SPI ExpressLRS
- Compatible with ExpressLRS V2.0 TX Module
- Couldn’t flash separately ExpressLRS firmware
ONBOARD FRSKY SPI D8/D16
- SPI BUS receiver
- CC2500 RF
- Compatible Non EU transmitter D8 model Channels: 8ch
- No ground interference ( Transmitter and receiver 1 m from the ground): 200meterFailsafe support
- Support Frsky D8/ D16 , Redpine , SFHSS
Includes
- 1x Happymodel X12 AIO 5-in-1 Board - F4 FC + 12A ESC + ELRS 2.4G RX
- 1x Connecting Wires Set
- 1x Hardware Set
- 1x Antenna
