Multirotor for racers and freestyle flyers
English  


Matek HUBOSD Eco H-Type


Price Unavailable

***IMPORTANT***  Without soldering anything to the board, please apply power to the board using alligator clips and make sure the LED is on. Contact us immediately if LED doesn't turn on! Return and Warranty claims are only considered on units that have not been soldered! Do not connect the HUBOSD 5V connector to any external voltages, doing so will destroy the HUBOSD



Details

HUBOSD8 has been engineered to provide the highest possible performance and reliability in a 46*36mm & 4 layers PCB. It is a multifunctional HUB with PDB, BEC 5V/2A &12V/500mA, Current sensor 140A, STOSD8. It is specially made for the mini FPV Quad. The BEC 12V is linear regulator, no LC Filter needed. Built-in STOSD8 can support Plug & Play, no complicated settings needed.

Download Manual here

Download STOSD Tool Software here

Specifications:

  • Input voltage range (3S-5S operation): 8 - 21VDC
  • PDB: 4x30A (Max.4x35A)
  • Regulated 5V and 12V outputs
  • Current Sensor 140A
  • Built-in STOSD8

Physical:

  • - 2oz copper, 4-layers &1.6mm PCB.
  • - 1x Battery input, 4x ESC outputs. 2x BEC 5V outputs, 2x BEC 12V outputs.
  • - Camera signal & Gnd pads, Video Transmitter Signal & Gnd pads
  • - 1x Serial port (RX, TX, G)
  • - Dimensions: 46x36x4mm, Weight: 8.5g
  • - Mounting holes 30.5mm square spacing,?3mm

PDB (ESC outputs)

  • Continuous current: 30A per output Peak current (10 seconds/minute): 35A per output

BEC 5V outputs

  • Designed for RC Receivers, Flight controllers, OSD, and Servos.
  • DC/DC synchronous buck regulator.
  • Voltage: 5.0 +/- 0.1VDC
  • Continuous current: 2 Amps (Max.2.5A 10s/minute)
  • Output Ripple: 40mV (VIn=16V, VOut=5V@2A load)
  • Short-circuit tolerant (5 seconds/minute)

BEC 12V outputs

  • Linear regulator, very low noise. LC Filter is needless.
  • Designed for Video TX or FPV camera.
  • Voltage: 12.0 +/- 0.3VDC (4~5S operation)
  • Continuous current: 500mA@16V IN, 400mA@20V IN
  • Short-circuit tolerant (2 seconds/minute)
  • If the battery is 3S LiPo, Output voltage=3S LiPo voltage - 1V

Current Sensor

  • 140A
  • If current >140A. STOSD display 140A
  • Model: HUBOSDE
  • 9 Units in Stock

Be the first to write a review.  Write a Review.

This product was added to our catalog on Friday 09 September, 2016.

Customers who bought this product also purchased...